OPERATION Pre-Operation Inspection 39 Item What To Do Bilge Drain water from the bilge before putting the craft in the water. Fuel/oil tank levels Check fuel/oil; add as necessary; inspect for presence of water. Jet pump water intake Inspect and remove any debris; ensure intake grate is secure; push rear of craft up and down in the water to flush sand out of wa- ter intake before starting. Throttle Check for proper operation. Steering Check for proper operation; in- spect control cable. Fire extinguisher Inspect condition/expiration date. Storage compartment Check and secure latches. Engine cover (seat) Remove and ventilate engine compartment before starting engine. Re-secure latches.
Item What To Do Battery Check fluid level/condition; vent hose must be clear and open. Hull Inspect hull for damage or cracks; clean off any marine growth. Drain plugs/bilge Inspect; clean; be sure each plug is tight, secure and doesn’t leak. Loose parts/ hoses Inspect for loose parts/hoses and connections; tighten as needed. Seat Check and secure latches. Loose ropes/ straps/clothing/ long hair Be sure that there are no loose ropes, straps, clothing, etc.; Long hair is tied back and se- cured. Riding gear Check operator and passenger for complete gear and proper fit. Switches/buttons Check for proper operation. Lanyard cord/ stop switch Check condition and operation.
Reverse System Check for proper operation.