OPERATION Pre-Operation Inspection Switches/Buttons Perform these checks while the watercraft is in the water: 3. If removing the lanyard lock plate successfully stopped the engine in the previous step, start the engine again and allow it to run for a few seconds. Depress the engine stop button. If the engine doesn’t stop immediately, remove the lanyard lock plate to stop the engine. Do not ride the watercraft. See your Polaris dealer for service before operating the watercraft. 1. Check the inside of the engine compartment for fuel or water leaks. Do not operate the watercraft until any leaks have been repaired and the engine compartment has been ventilated. 2.
Start the engine and let it run for a few seconds. Remove the lanyard lock plate (1) from the engine stop switch (2) to test operation. The engine should stop immediately. If it doesn’t, press the stop switch to stop the engine. Do not ride the watercraft. See your Polaris dealer for service before operating the watercraft. 2 1 48