MAINTENANCE AND LUBRICATION Extended Storage CAUTION Failure to fog the engine can result in serious engine corrosion during off season or extended storage. Always fog the engine as outlined before storing the watercraft for extended periods. 2. Start the engine and spray Polaris fogging oil into the hole in the intake cover (2) to ensure that all internal parts are properly coated. Spray the oil for two to three seconds in each hole and repeat to flood the engine with fogging oil. Immediately stop the engine. 2 Watercraft Engine Fogging Procedure Polaris recommends the use of fogging oil to prevent rust and corrosion on internal engine parts (i.e.
crankshaft, bearings, pistons, rings, cylinder walls). The fogging oil coats all internal parts for prevention of rust and corrosion, which in turn will extend the life of the engine. See page 101 for part numbers of Polaris products. CAUTION Operating the engine while the watercraft is out of the water will cause the engine to overheat and seize. Never operate the engine for more than 15 seconds while the watercraft is out of the water. 1. Remove the three caps (1) in the top of the air intake cover. 3. Replace the caps in the air intake cover. 1 93