Deutz — Unbenannt

Determining shim thickness for commencement of delivery injection pump replacement in case of service. Basic dimension L0 = 117.5 mm The old injection pump with shim is not required for such purpose. Example: The injection pump of cylinder 3 is to be replaced on a BF6M 2012. Procedure: Read off EP code for cylinder 3 from name plate under column ”EP“, e.g. 295 (Reading sequence: line 1 = cyl. 1, line 2 = cyl. 2, etc.) 1 Take corrected injection pump installation dimension (E K ) from table 3 according to EP code, e.g. 120.875 mm. Table 3 Read off code for injection pump length (A) from new injection pump, e.g. 42. Take basic dimension of injection pump (L 0 ) from table 1, e.g.

117.5 mm Determine theoretical shim thickness (T S ). T S = EK - (L 0 + A/100) T S = 120.875 mm - (117.5 mm + 42/100 mm) T S = 2.955 mm Select shim thickness (S S ) from table 2.

T S 2.955 mm = S S 3.0 mm 1.00.17 © 2004 / 0312 0361 E K (mm) EP- Cod E K e (mm) EP Cod - E K e (mm) EP- Code E K (mm) EP- Code 119.25 119.275 119.3 119.325 230 231 232 233 119.85 119.875 119.9 119.925 25 25 25 25 4 120.45 5 120.475 6 120.5 7 120.525 278 279 280 281 121.05 121.075 121.1 121.125 302 303 304 305 119.35 119.375 119.4 119.425 234 235 236 237 119.95 119.975 120.0 120.025 25 25 26 26 8 120.55 9 120.575 0 120.6 1 120.625 282 283 284 285 121.15 121.175 121.2 121.225 306 307 308 309 119.45 119.475 119.5 119.525 238 239 240 241 120.05 120.075 120.1 120.125 26 26 26 26 2 120.65 3 120.675 4 120.7 5 120.725 286 287 288 289 121.25 121.275 121.3 121.325 310 311 312 313 119.55 119.575 119.6 119.625 242 243 244 245 120.15 120.175 120.2 120.225 26 26 26 26 6 120.75 7 120.775 8 120.8 9 120.825 290 291 292 293 121.35 121.375 314 315 119.65 119.675 119.7 119.725 246 247 248 249 120.25 120.275 120.3 120.325 27 27 27 27 0 120.85 1 120.875 2 120.9 3 120.925 294 295 296 297 119.75 119.775 119.8 119.825 250 251 252 253 120.35 120.375 120.4 120.425 27 27 27 27 4 120.95 5 120.975 6 121.0 7 121.025 298 299 300 301 .875 295