Komatsu — Retard Speed Control (RSC) Adjust Dial

Operator Cab And Controls - Section 32 OM3204 Page 32-8 Override/Fault Reset Switch Retard Speed Control (RSC) Adjust Dial This push-button switch (9, Figure 32-3) is spring- loaded to the OFF position. When pushed in and held, this switch may be used for several functions. RSC adjust dial (12, Figure 32-3) allows the operator to vary the downhill truck speed that the retard speed control system will maintain when descending a grade. This function can be overridden by either the accelerator, retard lever, or retard pedal. When the dial is rotated counterclockwise toward this symbol, the truck will descend a grade at lower speeds. 1.

This switch permits the operator to override the body-up limit switch and move the truck forward when the selector switch is in FORWARD, the dump body is raised, and the brakes are released. When the dial is rotated clockwise toward this symbol, the truck speed will increase. Use of the override switch for this purpose is intended for emergency situations only! ALWAYS refer to the grade/speed retard chart in the operator's cab , and follow the recommenda- tions for truck operation. DO NOT exceed these rec- ommended MAXIMUM speeds when descending grades with a loaded truck. 2. The push button deactivates the retard pedal function when speed of truck is below 3 mph (4.8 kph). 3.

The override switch is also used to reset an electric system fault when indicated by a red warning light (Refer to Overhead Status/Warn- ing Indicators in this section. Throttle pedal position will override RSC setting. If operator depresses throttle pedal to increase truck speed, dynamic retarding will not come on unless truck overspeed setting is reached or foot operated retard pedal is used. When throttle pedal is released and RSC switch is on, dynamic retarding will come on at, or above, the RSC dialed speed and will adjust truck speed to, and maintain, the dialed speed. 10, Figure 32-3 - Blank This position is not used for the 930E.

To adjust RSC control, pull switch (11) ON and start with dial (12) rotated toward fastest speed while driv- ing truck at desired maximum speed. Relax throttle pedal to let truck coast and turn RSC adjusting dial slowly counterclockwise until dynamic retarding is activated. Dynamic retarding will now be activated automatically anytime the "set" speed is reached, the RSC switch is on, and throttle pedal is released. In some other truck models, this posi- tion is used for an engine idle switch. With RSC switch on and dial adjusted, the system will function as follows: As truck speed increases to the "set" speed and throttle pedal released, dynamic retarding will apply.

As truck speed tries to increase, the amount of retarding effort will automatically adjust to keep the selected speed. When truck speed decreases, the retarding effort is reduced to maintain the selected speed. If truck speed continues to decrease to approximately 3 mph (4.8 kph) below "set" speed, dynamic retarding will turn off automati- cally. If truck speed must be reduced further, the operator can turn the adjust dial to a new setting or Retard Speed Control (RSC) Switch Retard speed control switch (11, Figure 32-3) turns the system on and off.

Push the knob in for OFF and If the operator depresses the foot operated retard pedal and the retard effort called for is greater than that from the automatic system, the foot pedal retard with ing t peda is posi- slow witch. activ auto RSC With sys tem ON. d th “IN” “OFF” d "s N. d th ” “OFF” d "s ecreases, e selecte ecrease t et" speed “IN ” “OFF” ally. If tru c o d If perator ca epress the the oper n a “OU T ” “ON” p edal and t