hitachi — PREPARATION FOR PERFORMANCE TESTS

TROUBLESHOOTING / Troubleshooting B RELATIONSHIP BETWEEN MACHINE TROUBLE SYMPTOMS AND RELATED PARTS This table indicates the relationship between machine trouble symptoms and the potential problem parts, which may cause trouble if failed, and the evaluation methods of these components. T5-7-2 Parts Engine Control Dial Pump 1 Delivery Pressure Sensor Pump 2 Delivery Pressure Sensor Function • Instructs engine target speed. • Monitors pump delivery pressure to control HP mode, horsepower relief flow rate reducing and auto-power lift controls. • Monitors pump delivery pres- sure to control HP mode, horsepower, swing horse- power reducing and attach- ment mode controls.

Symptoms in control sys- tem when trouble occurs. • Engine speed does not change even if engine control dial is turned. • If discontinuity or shorted circuit occurs in engine con- trol dial, target speed of 1200 min-1 is used as back-up value. • If pump delivery pressure sensor output is 0.25 V or 4.75 V, following symptoms will be presented by back-up mode function. • If pump delivery pressure sensor output is 0.25 V or 4.75 V, following symptoms will be presented by back-up mode function. Symptoms in machine operation when trouble occurs. • Engine speed is kept un- changed from 1200 min-1. (Auto-idle system functions. Engine can be stopped by key switch.) • HP mode is inoperable.

(Even if operating arm roll-in and boom raise with power mode switch in HP mode po- sition, engine speed does not increase.) • As delivery pressure and flow rate of pump 1 are limited, operating speed is slow and power is weak except swing operation. • Engine easily stalls. • Under swing combined op- erations, swing power is weak. • During boom raise single op- eration, pressure does not increase (power is weak). • HP mode is inoperable. (Even if operating arm roll-in and boom raise with power mode switch in HP mode po- sition, engine speed does not increase.) • As delivery pressure and flow rate of pump 2 are limited, operation speed is slow and power is weak except bucket operation.

• Engine easily stalls. Evaluation By MC Fault Code Fault code 11101 is displayed. Fault code 11200 is displayed. Fault code 11202 is displayed. By Monitor Function Monitor Item: Engine Target Speed, EC Dial Angle (Displayed by built-in diagnosing system) Monitor Item: Pump 1 delivery pressure (Displayed by built-in diagnosing system) Monitor Item: Pump 2 delivery pressure (Displayed by built-in diagnosing system) Using Test Harness - - - Others - - - NOTE - - - Descriptions of Control (Operational Principle Section in T/M) T2-1 T2-1 T2-1