TROUBLESHOOTING / Troubleshooting B CORRELATION BETWEEN TROUBLE SYMPTOMS AND PART FAILURES This table indicates the relationship between machine troubles and parts contributing to the cause of the trouble if failed. z : Related, required to check { : Related. However, in case this component fails, other trouble symptom will be more noticeable so that this component will not be the direct cause of the trouble concerned. Engine System Troubleshooting T5-7-20 Trouble Symptom Parts E-1 E-2 E-3 Starter does not rotate. Even if starter rotates, engine does not start. When engine control dial is fully rotated, engine stalls.
Occasionally engine stalls during operation with engine control dial fully rotated and auto-idle ON. Engine speed is slower than specification in all operating range. Idle speed is faster or slower than specifica- tion.
MC (Main Controller) z ECM z ICF { Monitor Unit { Pump 1 Delivery Pressure Sensor Pump 2 Delivery Pressure Sensor Pump 1 Regulator Pressure Sensor Pump 2 Regulator Pressure Sensor Starter Cut Relay (R4) z ECM Main Relay (R14) Pressure Sensor (Boom Raise) Pressure Sensor (Arm Roll-In) Pressure Sensor (Attachment) Pilot Shut-Off Switch z Engine Stop Switch z Key Switch z Engine Control Dial Auto-Idle Switch Power Mode Switch { Battery Relay z Starter Relay 2 z Engine Electrical Equipment z { Engine Unit z z Remarks Check batteries. Check fuel system (Filters and piping).