TROUBLESHOOTING / Electrical System Inspection INSTRUCTIONS FOR DISCONNECTING CONNECTORS Push to Unlock and Separate Type (Most of connectors are “Push, Unlock and Sepa- rate Type”.) NOTE: 1. Connectors will not be easily separated even if the lock is pushed while being pulled. Push the lock first before pulling the connectors. 2. The lock is located on female side con nector (harness end side). Raise Lock, Pull and Separate Type Locations of This Type Connector Starter Relay 2 Pull and Separate Type IMPORTANT: Before pulling and separating, re- lease the wire lock in the hydraulic oil temperature sensor by using a pair of pincers.
Locations of This Type Connector Hydraulic Oil Temperature Sensor Dr. ZX Push Lock and Switch Lever Type Locations of This Type Connector Cab Harness to Main Harness ECM T107-04-05-002 T107-04-05-003 T107-04-05-004 T1J1-05-08-003 T5-8-3