hitachi — PREPARATION FOR PERFORMANCE TESTS

OPERATIONAL PERFORMANCE TEST / Component Test SOLENOID VALVE SET PRESSURE Preparation: 1. Stop the engine. 2. Push the air bleed valve on top of the hydraulic oil tank and release any remaining pressure. 3. Connect Dr. ZX and select the monitoring func- tion. When Dr. ZX is not available, use the pres- sure gauge. Remove the line from the solenoid valve to be measured. Install tee (ST 6451), hose (Parts Number: 4216453), adapter (ST 6461) and pressure gauge (ST 6942). Solenoid Valve Pressure Gauge T157-05-04-002 Hose Adapter Tee : 17 mm, 19 mm, 22 mm 4. Start the engine. Confirm that no oil leakage is observed at the pressure gauge connection. 5.

Maintain the hydraulic oil temperature at 50 ± 5 ° C (122 ± 41 ° F). Measurement: 1. Measurement conditions are as below. 2. Operate as instructed below for each measuring solenoid valve: Solenoid Valve SG: Turn the power digging switch ON and OFF. Solenoid Valve SI: Turn the travel mode switch ON and OFF. Solenoid Valve SF: Combined operation of boom lower and arm, or boom lower and bucket. Solenoid Valve SC: Turn the boom mode selector switch ON. Operate the front and swing opera- tion. 3. Read the values on both Dr. ZX and the pressure gauge. 4. Repeat the measurement three times and calcu- late the average values. Evaluation: Refer to the performance Standard Table in Group T4-2.

SC SF SI SG T1V1-03-07-007 T4-5-4 Engine Control Dial Power Mode Switch Auto-Idle Switch Work Mode Fast Idle HP Mode OFF Digging Mode Slow Idle HP Mode OFF Digging Mode