OPERATIONAL PERFORMANCE TEST / Component Test NOTE: In case pressures of all circuits are low, the pressure of the main relief valve may de- crease. In case pressures of specified cir- cuits are low, pressures of some other parts except the main relief valve may de- crease. Main Relief Valve Setting Adjustment Procedure When adjusting the increased pressure (when travel or power digging switch is ON), adjust the high-pressure side of main relief pressure. When adjusting the normal main relief pressure, ad- just the low-pressure side of main relief pressure.
When adjusting the high-pressure side of main relief pressure, the low-pressure side of main relief pres- sure setting is changed accordingly. Therefore, be sure to adjust the low-pressure side of main relief pressure after adjusting the high-pressure side of main relief pressure. High-pressure side of relief pressure adjustment pro- cedure. 1. Loosen nut (2). Lightly tighten plug (1) until the end of plug (1) comes into contact with sleeve A. Tighten lock nut (2). Main Relief Valve T1JB-04-05-004 1 2 3 : 30 mm Lock Nut (2) 4 : Less then 59 N m (6 kgf m, 44 lbf ft) 2. Loosen lock nut (4). Turn Plug (3) clockwise to adjust the relief pres- sure setting referring to the table below. 5 A :
41 mm Lock Nut (4) : Less then 98 N m (10 kgf m, 72 lbf ft) Low-pressure side of relief pressure adjustment pro- cedure. 3. Loosen lock nut (2). Turn plug (1) counter clockwise to adjust the re- lief pressure setting referring to the table below. Tighten lock nut (2). T16J-04-04-003 : 30 mm Lock Nut (2) : Less then 59 N m (6 kgf m, 44 lbf ft) 4. Check the set pressure again. 1, 3 NOTE: Approx. 4.5 MPa (46 kgf/cm 2 ) increase/decreases at a quarter turning. Pressure Decrease Pressure Increase W107-02-05-127 T4-5-9