OM4214 Automatic Lubrication System - Section 42 Page 42-1 AUTOMATIC LUBRICATION SYSTEM GENERAL DESCRIPTION The reciprocating action causes the pump cylinder to move up and down. The pump is a positive displacement, double-acting type as grease output occurs on both the up and the down stroke. The automatic lubrication system is a pressurized lubricant delivery system which delivers a controlled amount of lubricant to designated lube points. The system is controlled by an electronic timer which signals a solenoid valve to operate a hydraulic motor powered grease pump. Hydraulic oil for pump operation is supplied by the truck steering circuit.
During the down stroke, the pump cylinder is extended into the grease. Through the combination of shovel action and vacuum generated in the pump cylinder chamber, the grease is forced into the pump cylinder. Simultaneously, grease is discharged through the outlet of the pump. The volume of grease during intake is twice the amount of grease output during one cycle. During the upstroke, the inlet check valve closes. Half of the grease taken in during the previous stroke is transferred through the outlet check and discharged to the outlet port. Grease output is proportional to the hydraulic motor input flow.
A pump control manifold, mounted on top of the hydraulic motor, controls input flow and pressure. A 24VDC Solenoid mounted on the manifold turns the pump on and off. The pump is driven by the rotary motion of the hydraulic motor, which is then converted to reciprocating motion through an eccentric crank mechanism. Over-pressurizing the system, modifying parts, using incompatible chemicals and fluids, or using worn or damaged parts may result in equipment damage and/or serious personal injury. DO NOT exceed the stated maximum working pressure of the pump or the lowest rated component in the system. Do not alter or modify any part of this system unless approved by the factory.
Do not attempt to repair or disassemble the equipment while the system is pressurized. Ensure that all fluid connections are securely tightened before using this equipment. Always read and follow the fluid manufacturer's recommendations regarding fluid compatibility and the use of protective clothing and equipment. Check all equipment regularly. Repair or replace worn or damaged parts immediately. This equipment generates very high grease pressure. Extreme caution must be used when operating this equipment as material leaks from loose or ruptured components can inject fluid through the skin and into the body, causing serious bodily injury including possible need for amputation.
Adequate protection is recommended to prevent splashing of material onto skin or into the eyes. If any fluid appears to penetrate the skin, get emergency medical care immediately! Do not treat as a simple cut. Tell attending physician exactly what fluid was injected. FIGURE 42-1. PUMP & RESERVOIR 1. Hose From Filter 2. Outlet to Injectors 3. Hydraulic Motor 4. Pressure Reducing Valve 5. Solenoid Valve 6. Override Switch 7. Vent Valve 8. Pipe Plug 9. Pump Assembly 10. Flow Control Valve 11. Pressure Switch 12. Grease Reservoir