Yanmar — 5.Reassembly

Chapter 7 Reduction and Reversing Gear 3. Inspection and Servicing 3JH2 series Limited dimensions mm (3) Lap the large gear's cave and drive cone, pushing them together by hand. Dimensions 32.4 28.1 NOTE : When dismantled, the forward of reverse direc- tion of the drive cone must be clearly identified. (4) lf the wear of the V-groove of the drive cone is exces- sive, replace the part. NOTE : When replacing the drive cone, the new cone and forward large gear and reverse large gear must be lapped prior to assembly. The lapping procedure is described below. (4) Push and turn the large gear about 5 times both clockwise and counter-clockwise.

3-5-1 Lapping Procedure for Drive Cone (1) Coat the lapping powder onto the cave of the clutch gear (Lapping powder:67 micron silicon carbide #280) (5) After lapping them, wash them with washing oil. The lapped parts should be cleaned completely. (2) Set the large gear on the output shaft with a needle bearing and then set the drive cone on the output shaft. NOTE: Do not mix the combination of the lapped parts. The washing oil should be changed frequently in order to prevent residual powder being left on the parts. When assembling the drive cone, be sure to check its alignment. The larger chamfering face should be on the forward large gear side.

Printed in Japan A0A1015-0302 Printed in Japan A0A1015-0302 7-41 Standard dimensions KM3P1 KM3P3 32.7-33.3 KM35P1 29.25-29.75