OPERATION 3.8 ELECTRICAL EQUIPMENT IN CAB BASE 3.8.1 STANDARD COMPONENTS IN CAB BASE REMARK On shovels with electrical pre-heating systems there are addi- tional components in the cab base. Refer to page 159 for more information. The cab base may contain high tension electrical appli- ances. Access to the cab base for authorized service staff only. DO NOT touch cables and their terminals and connected components. Always contact authorized Electricians having the permission to work on medium and high volt- age systems. Legend for illustration Z26322 (1) Cab base door. Keep the door always locked, access to the cab base for authorized personnel only.
(2) Light switch (3) Main switch board (X2), refer to page 149 for switch board components. (4) Programmable logic controller (PLC) (5) Electronic pump control module (RC4) (6) Pressure switch DPST of the FIRE DETECTION; ACTUATION AND SUPPRESSION SYSTEM (special equipment). Refer to page 214 for more information. (7) Signal horn compressor (8) Controller of the VHMS system 147 WARNING WARNING