Komatsu — 3.8.2 SWITCH BOARD (X2) IN CAB BASE

OPERATION 3.8 ELECTRICAL EQUIPMENT IN CAB BASE Checking diagnostic fault codes of the engine electronic controlled fuel system QUANTUM and of the engine protection system REMARK The indicator lamps (H94. 1 ) STOP, (H95. 1 ) WARNING, and (H96. 1 ) FLUID indicate trouble conditions of engine 1 . The indicator lamps (H94. 2 ) STOP, (H95. 2 ) WARNING, and (H96. 2 ) FLUID indicate trouble conditions of engine 2 . With the engine diagnostic enable switch (S53) in ON position, the indicator lamps (H94) STOP, (H95) WARNING, and (H96) FLUID will illuminate and stay illuminated if no faults are present.

If active faults are present, then fault code flashout will start if the engine diagnostic switch is ON and the engine is off. The fault code will flash in the following sequence: 1. The WARNING lamp (H95) will flash. 2. A one second pause with both WARNING (H95) and STOP (H94) lamps off. 3. The STOP (H94) lamp will flash the recorded fault code with a one second pause between digits. 4. When the number has stopped flashing, the WARNING (H95) lamp will illuminate. 5. The fault code number will repeat in the same sequence. The FLUID lamp (H96) will remain on as long as a fault condition is present. To check for active fault codes proceed as follows: 1.

Stop the engines and turn the Excavator main key switch to OFF position. 2. Turn the engine diagnostic enable switch to ON position. The diagnostic switch is located on the operator console, see page 87 for more information. 3. All active QUANTUM faults are flashed out first on the red STOP indicator lamp (H94). After all QUANTUM fault codes are flashed out, the active engine protection system fault codes will be flashed out on the WARNING lamp (H95). Active faults must be corrected as soon as possible. Contact your Komatsu dealer for repair. REMARK For more information, refer to the separate Engine Operation and Maintenance Manual filed in volume 2 binder. 153 CAUTION CAUTION