OPERATION 3.9 PREHEATING SYSTEMS FOR OIL, COOLANT AND BATTERIES Engine Coolant and Engine Oil Reserve Tank Heating Legend for illustration Z 22553 (1) Coolant heating for rear engine 1 (E1), installed on RH side member of the main frame (2) Coolant heating for front engine 2 (E2), installed on LH side member of the main frame (3) Control box for coolant heating (4) Switch, coolant heater ON/OFF (5) Indicator light, coolant heating ON, (6) Water pump with motor (7) Coolant heating element and tank (8) Coolant flow switch (9) Not used (10) Engine oil heaters installed in the engine oil reserve tank (11) Thermostats for engine oil heaters installed in the engine oil reserve tank (12) Battery heater plates To activate the coolant heating, set main switch (1Q1) on the switch board in cab base to ON position.
The coolant heating can then be switched on with switch (4) on the control panel. The lamp (5) illuminates with coolant heating ON. Before starting the shovel engines, switch OFF the coolant heat- ers. REMARK For more information about the coolant heating system, refer to the operation manual *Coolant Heating System* filed in volume 2 binder. 163