Komatsu — 3.10 CHECKS BEFORE STARTING THE ENGINES

OPERATION 3.10 CHECKS BEFORE STARTING THE ENGINES Before starting the Engines, make sure that no one will be endangered when starting the Engines. CHECK THE FOLLOWING ITEMS Legend for illustration Z26334 (1) Engine oil pan dipstick oil level gauge (2) Oil filler tube for engine oil pan (3) Engine Electronic Fuel System Control Module (4) Fuel pump Walk-around Inspection Make a ”Walk-around” inspection of the Shovel. Refer to page 295 in the Maintenance Section for the daily inspection items. Engine oil level of Front and Rear Engine Check oil level with Shovel standing on level ground. Check oil level in engine oil pan with the dipstick oil gauge (1).

For accurate readings, the oil level should not be checked until the oil has set- tled into the oil pan after the engine has been shut down (about 5 minutes). REMARK The oil level in the engine oil pan can vary between the MIN and MAX marking on gauge (1) depending on the operating con- dition of the reserve system when the engine was stopped. With sufficient oil in the reserve tank and with the reserve system in proper working order, there is no need to fill the engine oil pan even with the oil level at the MIN mark on gauge (1). If the oil level is below the MIN marking on the gauge, corrective action must be taken. Fill the reserve tank and check the reserve system.

The function of each reserve system is monitored by an indicator light located on the "X2" switch board in the cab base. See section "SWITCH BOARD (X2) IN CAB BASE" for more information. Check the oil level in both engine oil reserve tanks, see page 271 for more information. Be sure to fill the corresponding reserve tank of rear engine -1- or the reserve tank of front engine -2- when the information mes- sage "Engine oil reserve tank 1 (or 2) empty" is being dis- played on the VHMS monitor in the operator’s cab. 169 CAUTION CAUTION