Komatsu — 3.10 CHECKS BEFORE STARTING THE ENGINES

OPERATION 3.10 CHECKS BEFORE STARTING THE ENGINES Coolant Level Legend for illustration Z26335 (3) Coolant expansion tank of front and rear engine radi- ators (4) Coolant level sight gauge on front and rear coolant expansion tanks (5) Cover plates on power house roof above front and rear radiator pressure caps (6) Radiator pressure caps DO NOT remove the radiator pressure cap (6), illust. Z26335 from a hot engine. Wait until the temperature is below 50°C before removing the pressure cap (6). Failure to do so can result in personal injury from heated coolant spray or steam. Press the red button on the radiator pressure cap to allow the pressure to escape.

Turn the radiator cap slowly counter- clockwise to the safety stop, then continue to turn until cap is free to be removed. The coolant level should be in the upper field of the sight gauges (4). If necessary add coolant via the swing down service arm to the MAX marking on the sight gauge. Refer to section "CENTRAL REFILLING SYSTEM" on page 230 for more information. REMARK Refer to the Engine Manual for the correct coolant composi- tion and filling procedure. Fill Engine Fuel Tank Engine fuel is flammable and can cause a fire or an explo- sion. Do not fill the fuel tank or service the fuel system near an open flame, welding, burning cigar or cigarettes, etc.

Fill the fuel tank at the end of the of the shift to prevent condensa- tion from forming. Fill the fuel tank via the swing down service arm. Refer to section "CENTRAL REFILLING SYSTEM" on page 230 for more information. Observe the fuel specifications in the engine operation and maintenance manual. 171 WARNING WARNING WARNING WARNING