OPERATION 3.11 STARTING THE ENGINES 3.11.1 STARTING PROCEDURE If the ambient temperature is below -25°C proceed according to step 7 on next page. REMARK Start the engines one after another, e.g. first rear engine 1 and then front engine 2. Both engines are started in the same way. 1. Insert battery main switch keys and turn to operating position. REMARK Start the engines with the lock lever (11) illust. Z26336 in the fully rear LOCKED position. When the engines are running move the lock lever fully to the front in FREE position. 2. Insert key into main switch (1) and turn to operating position. The high level alarm (2) must give an acoustic test signal.
If the alarm fails to function, corrective action must be taken. 3. Observe health monitor (3). Normally the initialization screen is displayed on the monitor, see page 91 for more informa- tion. 4. Set toggle switch (4) to low idle speed position. 5. Sound the signal horn (5). 6. Start the engines by turning starter switches (6 and 8). REMARK Each engine is equipped with a prelubrication system which is activated by the starter switches (6 and 8). Turning and holding the switch in the start position sends current to the prelubrication starter solenoid which then pre lubricates the engine.
This sole- noid timer prevents current from flowing to the conventional start- ing motor until adequate oil pressure has been achieved in the cam oil rifle. After a subsequent 3 second delay, current is then directed to the conventional starting motors for cranking the engine. Cold Weather Starting Aid Controlled Ether Injection The electronic control module (ECM) of the engine controls ether injection into the intake manifold while cranking if the engine is below a calibrated minimum coolant temperature or intake mani- fold temperature value. It will continue to inject ether until a cali- brated maximum engine speed has been reached. For more information refer to Engine Manual.
Never operate the starter longer than 30 seconds at a time in order to avoid damage. If the engine does not start within the first 30 seconds, wait 2 minutes before cranking again. As soon as the engines are running, check health monitor (3), for information. 177 CAUTION CAUTION