MAINTENANCE 4.6 LUBRICATION AND MAINTENANCE SCHEDULE 4.6.6 EXTENDED SERVICE INTERVALS FOR ENGINES EQUIPPED WITH ENGINE OIL MANAGEMENT SYSTEM Legend for illustration Z 26340 (1) Reserve oil tank. The reserve oil tank for the rear engine -1- is an integrated part of the LH main frame side member. The reserve oil tank for the front engine -2- is an integrated part of the RH main frame side member. (2) Oil level sight gauge (3) Suction line from reserve tank (4) Oil filters for the engine oil reserve system (5) Suction line to pumping unit (6) Pumping unit, located at the power frame just below the eliminator filter (15).
(7) Supply line from pumping unit to crankcase (8) Withdrawal oil line from engine oil pan to pump (9) Oil feed-back line to reserve tank (10) Ventilation line for reserve tank (11) Drain plug (12) Connector for refilling line from swing down service arm (13) Power frame (14) RH side member of main frame (15) Eliminator filter (16) Centrifuge Servicing Intervals Every 10 operating hours Check oil level in both engine oil pans with Excavator standing on level ground. Check also oil level in both reserve tanks at sight gauge (2), illust. Z26340.
REMARK The oil level in the engine oil pan can vary between the MIN and MAX marking on the oil level gauge depending on the operat- ing condition of the reserve system when the engine was stopped. With sufficient oil in the reserve tank and with the reserve system in proper working order, there is no need to fill the engine oil pan even with the oil level at the MIN mark on the level gauge. If the oil level is below the MIN marking on the gauge, corrective action must be taken. Fill the reserve tank and check the reserve sys- tem. The function of pumping unit (6) is monitored by an indicator light located on the -X2- switch board in the cab base.
See sec- tion "SWITCH BOARD (X2) IN CAB BASE" for more information. 271