Komatsu — 4.6.6 EXTENDED SERVICE INTERVALS FOR ENGINES EQUIPPED WITH ENGINE OIL MANAGEMENT SYSTEM

MAINTENANCE 4.6 LUBRICATION AND MAINTENANCE SCHEDULE Extended Service Intervals for Engines equipped with Engine Oil Management System Every 10 operating hours (continued) Be sure to fill the corresponding reserve tank of rear engine -1- or the reserve tank of front engine -2- when the information message Engine oil reserve tank 1 (or 2) empty is being dis- played on the VHMS monitor in the operator’s cab. Every 250 operating hours Carry out lubricating oil analysis. Every 500 operating hours (except for machines destined for Australia) The contents of each engine oil reserve tank is sufficient for approximately 500 hours of operation. Fill the reserve tanks via the swing down service arm.

Use engine oil according to the specifications in the Engine Operation and Maintenance Manual. Change both oil filter cartridges (4) of the reserve system. Every 4000 operating hours (except for machines des- tined for Australia) Change engine oil. Drain the oil from both engine oil pans and from both engine oil reserve tanks. See illustration Z26340 for location of the drain plugs (11) on the reserve tanks. It is recommended to change the oil when the oil level in the reserve tanks is near the minimum level. Every 500 operating hours (for machines destined for Australia only) Change both oil filter cartridges (4) of the reserve system.

Every 1000 operating hours (for machines destined for Australia only) Change engine oil. Drain the oil from both engine oil pans and from both engine oil reserve tanks. See illustration Z26340 for location of the drain plugs (11) on the reserve tanks. It is recommended to change the oil when the oil level in the reserve tanks is near the minimum level. REMARK After the engine oil has been drained from both engine oil pans and from both reserve tanks, fill both engine oil pans and both reserve tanks via the swing down service arm. See section Central Refilling System on page 230 for more information. DO NOT use the oil in the reserve tanks to fill the engine oil pans after an oil change.

Refer also to the Engine Operation and Maintenance Manual for oil change procedure and oil specifications. 273