MAINTENANCE 4.9 EVERY 50 OPERATING HOURS OR WEEKLY 4.9.1 SWING GEARS, BRAKE HOUSINGS AND MOTOR ADAPTER HOUSINGS - CHECK OIL LEVELS REMARK The machine can be equipped either with swing gears of manufacturer SIEBENHAAR or of manufacturer L&S. Refer to the data plate on each swing gear housing to find out the manufac- turer of the swing gear.
Swing Gears manufactured by SIEBENHAAR Legend for illustration Z26332 I Front swing gear II Rear swing gear (A) Position of oil level gauge for checking the oil level in swing gears and motor adapter housings (B) Position of oil level gauge for checking the oil level in brake housings (4) Oil level gauges for swing gears (6) Oil level gauges for motor adapter housings (8) Oil level gauges for brake housings (11) Drain coupling or evacuation nozzle for Wiggins system (12) Chain to secure rear gear access hatch (13) Rear gear access hatch CHECK SWING GEAR OIL LEVEL REMARK To access the rear swing gear (II), illust.
Z26332, raise the access hatch (13) in the walkway and secure against accidental falling using chain (12). 1. Remove oil level gauge (4) of both swing gears and wipe it clean. 2. Insert the gauge but DO NOT screw in, see detail -A-. 3. Remove the gauge. The oil level should be at the upper mark of gauge (4). 4. If necessary add the specified gear oil through the filler open- ing. 5. Insert both gauges (4) and tighten securely 6. Remove breather filter (10) from both swing gears. Blow out with compressed air from inside to outside and reinstall. 7. Close hatch (13) and tighten the fastening bolt. 309