Komatsu — 4.9.1 SWING GEARS, BRAKE HOUSINGS AND MOTOR ADAPTER HOUSINGS - CHECK OIL LEVELS

MAINTENANCE 4.9 EVERY 50 OPERATING HOURS OR WEEKLY Swing Gears, Brake Housings and Motor Adapter Housings - Check Oil Levels (continued) CHECK BRAKE HOUSING OIL LEVEL 1. Remove oil level gauge (8) of both brake housings and wipe it clean. 2. Screw in the oil level gauge, see detail -B-. 3. Remove the gauge. REMARK The upper mark on gauge (8) indicates the correct oil level with the oil hot. The lower mark indicates the correct oil level with the oil cold. With cold oil, the oil level should be at the lower mark of gauge (8). With hot oil, the oil level should be just below the upper mark of gauge (8). 4.

If necessary add engine oil SAE 10 or hydraulic oil HLP 22 or HLP 32 through filler opening. DO NOT overfill the brake housing, otherwise the brake could be damaged due to over- heating. 5. Insert both gauges (8) and tighten securely. 6. Remove breather filter from pipe (7), see illustration Z26450 on next page, from both brake housings. 7. Blow out with compressed air from inside to outside and rein- stall. CHECK MOTOR ADAPTER HOUSING OIL LEVEL 1. Remove oil level gauge (6) of both housings and wipe it clean. 2. Insert the gauge but DO NOT screw in, see detail -A-. 3. Remove the gauge. The oil level should be at the upper mark of gauge (6). 4.

If necessary add engine oil SAE 10 or hydraulic oil HLP 22 or HLP 32 through filler opening. 5. Reinstall both oil level gauges and tighten securely. 311