MAINTENANCE 4.12 EVERY 1000 OPERATING HOURS OR EVERY 6 MONTH FILTER SERVICE Clean or replace pressure filter elements, illust. Z 22515, as follows: 1. Place working equipment on the ground and shut-off the engines. Relieve pressure in the hydraulic system according to page 209 in the operation section. 2. Place a suitable container below the filter in order to collect outflowing oil. 3. Remove plug (A) and drain the oil. 4. Unscrew case (C) of the respective filter and clean the filter case. NOTICE Carefully inspect elements for damage. Always install new elements if ruptures or other damages are found. 5. Remove element (F) and clean.
Take care not to contaminate the "Clean" inside of the element when flushing. 6. Inspect O-rings and back-up ring. Replace if necessary. 7. Install drain plug (A) with new packing ring (B). 8. Lubricate the thread at the filter head and at filter case (C) with multi-purpose grease K2K. 9. Insert the cleaned element or a new element (F) with new O- ring (G). 10. Fill the case (C) half way up with clean hydraulic oil. 11. Screw the case (C) into the head and tighten. 12. After short operating period check filter for leakage. 13. Check restriction indicator (H) for proper mounting and good condition.
NOTICE Replace elements (F) after three cleanings or after every 5000 operating hours, whichever occurs first. 427