Komatsu — 4.13.1 HYDRAULIC SYSTEM - CHANGE OIL, REPLACE SUCTION STRAINERS AND PULSATION DAMPER

MAINTENANCE 4.13 EVERY 2000 OPERATING HOURS OR YEARLY HYDRAULIC SYSTEM - CHANGE OIL, REPLACE SUCTION STRAINERS AND PULSATION DAMPER Legend for illust. Z 21787 (6) Hand wheel of main shut off valve between main oil reservoir and suction oil reservoir To open the valve, turn hand wheel (6) CCW to the stop To close the valve, turn hand wheel (6) CW to the stop NOTICE Before starting the engines, make sure the shut off valve is completely open by turning the hand wheel (6) fully to the left (CCW). (11) Compensator (12) Intermediate pipe REMARK On the bottom of the intermediate pipe there is a cover for inspection of strainer (14).

(13) Gaskets (14) Suction oil strainer (15) Suction oil reservoir (16) Drain coupling Replace suction strainer (14) Attach drain hose (part of tool set) to coupling (16) and drain oil from suction oil reservoir. Remove intermediate pipe (12) and strainer (14). Install new strainer (14) with new gaskets (13). REMARK For inspection of strainer (14) between oil changes proceed as follows: 1. Close main shut-off valve (6). 2. Remove drain plug from bottom cover and drain the oil from intermediate pipe (12). 3. Remove bottom cover. Inspect strainer (14) and replace if necessary. 4. Install bottom cover using a new O-ring. 5.

Open main shut-off valve (6) and bleed the air from suction oil reservoir. Check hydraulic oil level and add oil as necessary. REMARK There are six further strainers installed in the suction oil reser- voir (15). Refer to page 447 for replacement instructions. 445