MAINTENANCE 4.14 EVERY 3000 OPERATING HOURS HOWEVER AT LEAST ONCE A YEAR 4.14.1 SWING GEARS, BRAKE HOUSINGS AND MOTOR ADAPTER HOUSINGS - CHANGE OIL REMARK The machine can be equipped either with swing gears of manufacturer SIEBENHAAR or of manufacturer L&S. Refer to the data plate on each swing gear housing to find out the manufac- turer of the swing gear.
Swing gears manufactured by SIEBENHAAR Legend for illustration Z26450 (I) Front swing gear (II) Rear swing gear (1) Swing gear (Front and Rear) (2) Brake housing (3) Compensator oil tank for swing gear (4) Oil level gauge for swing gear (5) Oil drain plug for motor adapter housing (6) Oil level gauge for motor adapter housing (7) Breather filter for brake housing (8) Oil level gauge for brake housing (9) Oil drain plug for brake housing (10) Breather filter (11) Drain coupling or evacuation nozzle for Wiggins system Swing Gears, change oil: 1. Use adequate working platform for draining the oil. Place receptacles of sufficient capacity (approx. 100 liter) below each drain coupling (11).
Attach drain hose (part of tool set) to drain coupling (11). Remove parts (4 and 10) to speed up draining. 2. Clean breather filter (10) with compressed air from inside to outside and re-install. 3. After the oil is completely drained, flush the gear with the reg- ular gear oil. 4. Remove drain hose from coupling (11) and attach the protec- tion cap onto the drain coupling. 5. Fill gear housing through filler pipe with fresh oil up to the MAX mark on oil level gauge (4), see page 459 for details. 455