OPERATION 3.3 OPERATOR’S CAB - CONTROLS Switch Board Legend for illustration Z26319 (1) Key operated main switch After switching OFF main switch (1), wait at least 3 minutes before switching OFF the battery main switches. VHMS needs this period for saving data. If batteries are switched OFF before this time period is over, data will be lost. (2) High level alarm: Automatic engine shutdown . The high level alarm (2) will sound approximately 10 seconds before an automatic engine shutdown occurs and will continue to sound during the 10 second period. At the same time a blinking message *SHUTDOWN* will be displayed on the VHMS monitor.
Use the time period to move the machine to a safe place and lower the attachment to the ground. Inform service about the shutdown condition. (3) Strike button, emergency shut down of both engines and pilot control sys- tem cut out. In case of emergency push in this button to stop both engines and to cut out the pilot control circuit. DO NOT use for normal stopping procedure. For releasing the switch, turn and pull-up the strike button. (4) WARNING lamp (Yellow) of rear engine 1. This lamp is used to monitor engine out-of-range condition, in case the VHMS Monitor fails to function.
When this lamp illuminates, the engine can still be operated until end of shift, but it can lose some system features which sometimes results in power loss (derate condition). Inform Service about the engine problem. (5) STOP lamp (Red) of rear engine 1. This lamp is used to monitor engine out-of-range condition, in case the VHMS Monitor fails to function. When this lamp illuminates, stop the engine operation in a safe manner immedi- ately. The engine monitoring system CENSE or the electronic control mod- ule ECM will initiate automatic engine shutdown due to serious engine problem. Inform Service about the engine failure.
(6) Rotary switch REAR Engine 1 START (7) Rotary switch REAR Engine 1 STOP 81 CAUTION WARNING WARNING