Komatsu — 3.3.4 INTERFACE PANEL FOR DIAGNOSTICS

OPERATION 3.3 OPERATOR’S CAB - CONTROLS 3.3.4 INTERFACE PANEL FOR DIAGNOSTICS Legend for illustration Z26320 (1) Interface panel on rear operator’s console (X36) Data link connector for programming the VHMS monitor (X27A) Data link connector for download of VHMS memory data (X13) Data link connector for Electronic Tool connection to the electronic pump control system RC4 (X52.1) Data link connector for Electronic Tool connection to the ECM of engine number 1 monitoring system and the electronic controlled fuel system QUANTUM. (X52.2) Data link connector for Electronic Tool connection to the ECM of engine number 2 monitoring system and the electronic controlled fuel system QUANTUM.

(S53) Enable switch for engine diagnostics. For download of engine data and for programming the engine Elec- troic Control Modules (ECM’s) stop the engine and set main key switch to off position, then turn on switch (S53). Use same procedure for checking active fault codes of the engine via service lamps located on switch board (X2) in the cab base. Refer to page 149 for more information. (2) Portable fire extinguisher. Observe the local Fire Prevention Regulations in regard to number, size and location of portable fire extinguishers. Make sure the fire extinguisher is always charged and ready for use. 87