. OPERATION EXPLANATION OF COMPONENTS JOYSTICK (STEERING, DIRECTIONAL AND GEAR SHIFT LEVER) (PCSS lever) Lever (2) is used to switch direction of travel and to steer the machine. Forward-reverse shifting Position (a): FORWARD Position (b): REVERSE Position N: Neutral Move to the front to drive forward; move to the rear to drive in reverse. right to turn the machine. The 3 - 57 REMARK PCCS: Palm co mmand control system Steering turn ht turn oved to the front or rear, operate the lever partially to the left or r n gradually in the same direction as the lever is operated. ved fully to the left or right, the machine will turn in a small radius. Position (L): Left Position (R):
Rig With the lever m he machine will tur n gradually in the sam e direction as th e lever is operated If the lever is mo ved fully to the left or right, the machin e will turn in a small REMARK If the lever is rel eased when steering t he machine, the lever will ret urn to the (a) pos ition or the ( b) position a nd the machine will be returned to straight m Gear shifting When the joystic k (steering, direction, and gearshift lev FORWARD or R ess switch (c) or the transmission up switch (c): Ea sh ifts up one speed ran down switch (d): Each time the switch i s pressed, the tr shifts down one spee d range. For details of the maximum travel spee d in each speed "SPECIFICATIO NS (PAGE 5-2)".
REMARK When the tra nsmission is shifted, th e speed range being used i s displayed on th e display pa nel on the m onitor panel. Example: Neutral: N is FORWARD 2 REVERSE 3 When the pa displayed on the display panel. nd: F2 is displayed on the display panel. rd: R3 is displayed on the display panel. rking lever is locked, P is displayed. the gearshift operation using the shift mode, see "SHIFTING GEAR (PAGE 3-130)". Shift mode displayed on the displ nd: F2 is displayed on the display pan rd: R3 is displayed on the display pane rking lever is locked, P is displayed. For details of the gearshift operatio n using the shift mode, see " SHIFTING GEA 130)".
Shift mode selection me ans the operation to se t the selected s peed range beforehand in th e N position.