Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION CHECK COOLANT LEVEL, ADD COOLANT WARNING check that the coolant is between the FULL and LOW marks on sub-tank (1). If the coolant level is low, add coolant to the FULL level through the coolant filler port in sub-tank (1). REMARK The coolant may overflow from the sub-tank drain hose. This is no problem. It occurs because too much coolant has been added. 2. After adding coolant, tighten the cap securely. 3 - 98 Normally, do no t open the radiator cap. Whe n checki ng the coola nt level, check the sub-tank when t D o not remove t he cap when the r adiator c oolant is hot. Boiling coolant may spurt out.

After the c oolant temperature goes down, turn the c ap slowly to releas e the pressure, th en remove it. 1. Open the eng ine side cover o n the left side of t he chassis , and 3. I f the sub-ta nk becomes e mpty, th ere is ater l r eakage. Afte r checking, repai r any abnormalit y immediately. It no abnormal ity is found, che ck the l evel of t he water in the adiator. If it density as is low, add Supe rcoolan t (AF-NA C) of the s ame the Supercoola nt in the radiator, then add e engine side cover. Supercoolan t to the sub-tank. 4. After adding coolant, close th e engine side co