Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL WARNING at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil 3 - 103 Parts and oil are temperature to go 1. Open the e ngine side cover on the left side of the c 2. 3. 4. ( I ( 5. I 6. I 2. Remove dip stick (G), and wipe the oil off with a clot h. it. n dipstick l filler port e oil from urely and 3. Fully insert dipstick (G) into filler pipe, then remove 4. The oil level should be between the H and L marks o G). f the oil lev el is below the L mark, add oil through oi F). 5.

I f the oil is a bove the H mark, drain the excess engin drain plug ( P), and check the oil level again. el is correct, tighten the oil filler cap sec gine side cover. 6. I f the oil lev close the en REMARK l level with the engine stopped. Check the oi When check ing the oil level immediately after stoppin g the engine, wait for at least 15 minutes after stopping the engine befor e starting the inspection operation. before starting inspection. to remove the air inside the crankcase. If the machin e is at an angle, set it in a level position When addin g oil, remove the dipstick from the guide to remove the air inside the crankcase.