. OPERATION TRANSPORTATION TRANSPORTATION LOADING, UNLOADING WORK WARNING 3 - 165 When transporting the machine, o bserve all related laws and regulations, and be careful t Make sure the ramp has sufficient width, length and thickness to enable the machine to be safely loaded and unloaded If the ramp sags appreciably, reinfo When loading and unloading the m achine, park the trailer on a flat firm roadbed. Keep a fairly long distance between the road shoulder and the machine. rriage to prevent the machine from slipping to the side on slopes. nd free of grease, oil, ice and loose materials.
Remove the mud from the underca rriage to prevent the machine from slipping to the side on slop Be sure the ramp surface is clean a nd free of grease, oil, ice and loose materials. Never change the direction of trave l when on the ramps. If it is necessary to change direction, driv e off the ramps and c orrect the direction, then drive on to the r amps again. When loading or unloading, alway s use ramps or a platform. Proceed LOADING ground only. the edge of a road. 1. Load and unload on firm level Maintain a safe distance from 2.
Apply the trailer brakes secure tires to prevent the trailer from Set left and right ramps equally spaced to the left a Make angle of installation ramps bend a large am machine, put blocks under bending. 1. Load and unload on firm level Maintain a safe distance from 2. Apply the trailer brakes secure ly, then put blocks (1) under the tires to prevent the trailer from moving. (2) parallel to each other and Set left and right ramps nd right of center (3) of the trailer. (4) a maximum of 15°. If the ount under the weight of the the ramps to prevent them from 3. Set parking brake lever to the FREE position (F). 4. Set the transmission in the 1s idle. t gear and run the engine at low 5.
Set the travel direction toward the ramps and drive slowly. 6. The center of gravity of the machine shifts suddenly at the border between the ramps a unbalanced and becomes da border slowly. nd trailer, and the machine is ngerous. Accordingly, pass the fied position on the trailer. 7. Stop the machine at the speci