Komatsu — IF BATTERY IS DISCHARGED

. OPERATION TROUBLESHOOTING IF BATTERY IS DISCHARGED WARNING (A) (B) When removing, disconnect the cable from the ground terminal first. When installing, connect the cable to the positive(+) terminal first. 3 - 180 It is dangerous to charge a batte ry when installed on a machine. Make sure that it is removed before ch arging. battery, stop the engine and turn the When checking or handling the starting switch key to the OFF p The battery generates hydrogen osition. gas, so there is a hazard of explosion. Do not bring lighted cigarettes n ear the battery, or do anything that will cause sparks. Battery electrolyte is dilute sulfu ric acid, and it will attack your clothes and skin.

If it gets on your clothe s or on your skin, immediately wash it off with a large amount of water. If it gets in your eyes, wash it out with fresh water and consult a doctor . ys wear safety glasses and rubber When handling batteries, alwa gloves. When removing the battery, first disconnect the cable from the ground (normally the negative (-) termina l). When installing, install the positive (+) terminal first. If a tool touches the positive ter minal and the chassis, there is danger that it will cause a spark, so be e xtremely careful. If the terminals are loose, there is danger that the defective contact may generate sparks that will cause a n explosion.

When removing or installing the terminals, check which is the positive (+) terminal and which is the neg ative (-) terminal. REMOVAL AND INSTALLAT ION OF BATTERY remove the ground cable (normally connected to the negative (-) terminal). Before removing the battery, remove the ground cable (normally connected to the negative (- If any tool touches between t he positive terminal and the chassis , ther e is a hazard of sparks being generated. When installing the battery, c onnect the ground cable last. ecure it with battery hold-down. battery terminal: 9.8 to 14.7 Nm (1 to 1.5 kgm, 7.2 to 10.8 lbft) When replacing the battery, s ecure it with battery hold-down.

Tightening torque:Tightening battery terminal: 9.8 to 14.7 Nm (1 t o 1.5 REMOVAL, INSTALLATION OF B ATTERY CABLE ery, remove the ground cable 1. Open the battery cover (1). 2. Before removing the batt (normally connected to the touches between the positiv danger of sparks being g terminal and remove the wir 3. When installing, connect th Insert the terminal cable on Tightening torque: 9.8 to 19 lbft) 4. Close battery cover (1). 1. Open the battery cover (1). 2. Before removing the batt negative (-) terminal). If any tool e terminal and the chassis, there is enerated. Loosen the nut of the es from the battery. e ground cable last. the battery, then tighten the nut. 3.

When installing, connect th the battery, then tighten the nut. .6 Nm (1.0 to 2.0 kgm , 7.2 to 14.5