Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE CLEAN AND CHECK RADIATOR FINS, OIL COOLER FINS, AFTERCOOLER FINS CLEANING BY ROTATING COOLING FAN IN REVERSE DIRECTION direction, first run the engine at low idling, then stop it. The dust and dirt stuck to the radiator and cooler can be blown out "FAN REVERSE MODE (PAGE 3-49)". 4 - 35 en installing end bit (4), put top f ace (5) of th e end b it in ht contact with st opper (6), then t ighten the bolt. 6. After s everal hours of ru nning, retourqu e the nuts. Carry out t his procedure if t here is any mud or dirt stuc k to th e radiator or REMARK Check the hydraulic cooler hoses.

If any ho se is cracke d or hardened by a ge, replace with a new hose. Also check and tighte n all loose hose c lamps. NOTICE When rotati ng the cooling fan in the reverse direc tion, be extremely careful of flying du st. When stopp ing the engine whe n the cooling fan is rotating in the reverse by rotating the cooling fan i n the reverse dir 1. Turn s tarting switch (1) to the "OFF" po sition and s top the engine 2. Turn s tarting switch (1) to the "ON" pos 3. Set the fan reverse mod e on the user m tails of the metho d of setting the f