Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CHECK AND ADJUST AIR CONDITIONER CHECK LEVEL OF REFRIGERANT(GAS) WARNING 4 - 45 CHECK TENSION OF C OMPRESSOR BELT ckens, it is likely to slip, lowering the cooling If t he driving belt sla efficiency. Depress the mid point between drive pulley (1) and compressor pulley (2 ) with a thumb (approx. 58.8 N {6 k g}) every now and then to mak e sure that deflection am ount (A) is a pprox. 10 mm (0.4 in). When it is a new belt , elongation is expected in the initial period of use, so be sure to replacement.

make an adjustment in a few days after the he When handling refri gerant gas, always follow lo cal laws and regulation The refrigerant used in the cooler is colorless an d odorless a nd does no t harm the atmosphere, bu t if the liquid gets into your eyes or on your han ds, it may cause loss of sig ht or frostbite , so never loosen any part of the refr If t he level of the refr igerant (gas) is low, the cooling effe ct will be reduced. Run the en gine at high idle, and c heck the flo w of t he refrigerant gas (R13 4a) in the refrigerant circ uit through the sight glass (2) (inspection window) of the receiver ( 1) when the cooler is running at high spee d. (A) Correct:

No bu bbles are included in th (B) Low: Bubbles are included in the flow pass continuously) ss, transparent (bubbles (C) None: Colorle REMARK When there are b ubbles, the refrigerant gas level is low, so contact your refrigerant dealer to have refrigeran contact added. If the air c onditioner is run with the refrigerant gas level low, it will cause dama New Freon R134 a is used as the refrigera