Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE 4 - 49 BLEEDING AIR IN HYDRAULIC SYSTEM See "OPERATIONS AND CHECK S A FTER STARTING ENGINE (PAG Since the e ngine m ust be started a nd t he blade mus t be operated, see OPERATION NOTICE If the engine i s run at h igh speed i mmediatel y after startup o r a cylinder is pushed u p to i ts stroke e nd, air taken inside the cylinder may cause d amage to the piston 1. Bleedin g air fro m cylinder 1) Run the eng ine at low idle, and extend and r etrac t eac h cylinder 4 to 5 times, taking care that a cylinder is not moved t o the e nd of its stroke. (Stop the cylinder a pprox.

100 mm (3.9 in) short of its stroke end) 2) Nex t, opera te eac h cylinde r 3 t o 4 times to th e en d of it s stroke. 3) Finally, ope rate each cylinder 4 to 5 times to the e nd o f its stroke to c ompletel y remove t he air.