. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 4 - 51 4. Operate switch (3) o f the electric priming pump to the ON position. Lamp (4) wi start. ll flash and the electric priming pump will REMARK ump switch has a built-in timer, and this actuates and stops the pump automatically. hing, the electric priming pump will stop, but this does not indicate any abnormality.
The electric priming p ump switch has a built-in timer, and this a ctuates and stops the p While the lamp is flas hing, the electric priming pump will stop, b ut this does not indicat e any abnormality If the switch is turned t o the OFF position when the lamp is lighte d up, the lamp will go out and the electric p riming pump will stop. 5. When the specified t ime (approx. 7 minutes) has passed, lamp (4) automatically goes out and the electric electric priming pump stops. 6.
If the fuel has been d rained from the fuel circuit, such as when the engine has run out of fuel and stopped , or maintenance has bee switch (3) for the el automatically (lamp g n carried out on the fuel hoses or tubes, or the supply pump has been replaced, t urn the ectric priming pump to the ON position again after the electric priming pump stops oes out). oes out, the air bleed operation is completed. pump 7. When the lamp (4) g oes out, the air bleed operation is comple 8. After the air is compl etely bled from the fuel circuit and the engine starts, stop the engine and close air bleed gine starts, stop the en gine and close ai r bleed valve (2). If the engine does not the air.
start, the air bleed operation has probably not been completed. R epeat Steps 1-5 to bleed NOTICE Do not keep the starting mo tor rotating continuously for more than 20 sec If the engine will not start, w ait for at least 2 minutes before trying to start