. MAINTENANCE SERVICE PROCEDURE CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING the oil level again. REMARK level position before 4 - 58 The oil is at high te mperature immediately after the machine has been operated. Wait for the oil to coo l down before starting the operation. 1. Stop the ma chine so that drain plug (1) is at the bottom 2. Remove oil level plug (2) and check whether the fina case is filled with oil to lower edge of th 3. If the oil leve overflows fro l is low, remove plug (3) an m oil level plug (2). d add engine oil until it CHECK OIL LEVEL IN DAMPER CASE, ADD OIL side of the machine. off with a cloth. hen remove it. 1. 2. 3. 4. 1.
Open the en gine side cover on the left side of the machine. 2. Remove dip stick (G), and wipe the oil 3. Fully insert d ipstick (G) into filler pipe, t 4. The oil shoul d be between the H and L marks on dipstick (G). If the oil is below the L mark, add oil through the dipstick t. insertion por 5. If the oil is ab ove the H mark, remove th e undercover under the machine, dra check Check the oil level while the engine is s I f the machi ne is inclined, set it in a oil level. c hecking the