. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE fuel or oil, then install it to ( 0.02 -0.046 kgm, 0.1 - 0.3 8. Clean the filter holder, fill the new filter cartridge with clean fuel, coat the packing surface thinly with oil, then install to the filter holder. 4 - 65 4. Remove seal (4) from transpare 5. If transparent cap (3) is damage Coat new seal (4) with clean transparent cap (3). 6. Install transparent cap (3) to new Tightening torque for transpar 10.0 Nm (1.0 kgm, 7.2 lbft) Tightening torque for transpar 7. Check that the drain plug at the is tightened securely. Tightening torque:
0.2 - 0.45Nm lbft) NOTICE When adding fuel, do not remove cap small holes (A) on the dirty side. After adding fuel, remove cap (B) and Always fill with clean fuel. Be careful the fuel. In particular, center portion is cap (B) when adding fuel. Be careful n portion on the clean side. 9. When installing, tighten until the packing surface contacts the seal surface of the filter hold er, then tighten it 3/4 of a turn. If the filter cartridge is tightened too far, the packing will be damaged and this will lead to l eakage of fuel. If the filter cartridge is too loose, fuel w ill also leak from the packing, so always tighten the corr ect amount. ter.
When tightening with a filter w rench, be extremely careful not to dent or damage the fil 10. After replacing the filter cartridge , start the engine and run it at low idling for 10 minutes. Check for leakage of oil from the filter seal surface. If any oil is leaking, check the tightening of the filter cartridge. If there is still oil leakage, repea t Steps 1 - 5 to remove the filter cartridge, and if any da mage or embedded foreign material in the packing su rface is found, replace it with a new cartridge and repeat Steps 6 - 13 to install it.