Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE Tightening torque for drain plug (P): 68.6 ± 9.81 Nm (7 ± 1 kgm , 50.6 ± 7.2 lbft) Tightening torque for drain valve (2): 63.7 ± 14.7 Nm (6.5 ± 1. 5 kgm , 47 ± 10.8 lbft) 4 - 69 3. 4. 3. Taking care n ot to get oil over yourself, remove drain p lug (P) slowly, then loosen drain valve (2) and drai n the oil. Be careful not to loosen the drain valve too much and deform the stopper pin inside the valv 4. Check the dr ained Komatsu distri butor. contact your 5. Tighte n drain 6. Using t he filter wrench, turn full-flow filter cartridge (3) To prevent ge tting oil on yourself, do not carry out this operation from immediately under the 7.

Clean t he filter holder, fill the new filter cartridge with en gine oil, coat the packing surface and t hread with e ngine oil (or coat it th inly with grease), then install the filter c REMAR Check that there is no old packing stuck to the filter holder. If there is any old packing stuck to the filter, it will c ause leakag e of