Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE (F)Front of the machine 7. Loosen mounting bolt (10) of the scavenging pump strainer, then remove cover (11). 8. Remove strainer (12). 9. Remove any dirt stuck to strainer (12), then wash it in clean diesel oil or flushing oil. Wash the removed parts and the inside of the case at the same time. 10. Install the strainers in their original position. 4 - 72 2. Remov e inspecti on cover (3) of the undercover on the bottom rear of the machine as follows. 1) Remove 2 bolts (4) on the machine front end. 2) Hold down cover (3) and remove 2 bolts (5) on the machine rear end gradually.

(Rainwater or other accumulated water may flow out, so be careful.) 3) Lower cover (3) gradually and open it. (The front side of the cover is hinged.) The strainer can be seen at top portion P. rear of t he machi ne as follow s. machine front end. 1) Remove 2 bolt s (4) on the machine front end 2) Hold down cov er (3) and re move 2 bolts (5) o n the machine rear e nd gradually. (Rainw ater or other accu mulated water may flow out, so be carefu l.) 3) Lowe r cover (3 ) gradually a nd open it. (The fr ont side of the cover is hinge d.) an be seen at top portion P. The s trainer c an be seen 3. Remov e drain pl ug (P2) in th e strainer cover, an d drain the oil (approx .

4 l iters ( 1.06 US gal )) collected inside t he piping. 4. Loosen mountin g bolt (6) of the power train strainer, and . 8), then remove strainer (9). stuck to strainer (9), then wash it in clean and 5. remove Remov cover (7) e spring ( 6. Remov e any dirt stuck to st rainer (9), then wa diesel o il or flushi ng oil. Wash the removed parts and the inside of the c ase at the same time.