SYSTEM / Control System OUTLINE MC (Main Controller) is used to control the machine operations. The signals from engine control dial, various sensors and switches are sent to MC and processed in the logic circuit. MC sends the signals equivalent to the target engine speed to ECM (Engine Control Module) by using CAN communication in order to control the engine. (Refer to ECM System/ SYSTEM.) MC drives the solenoid valve unit and torque control solenoid valve in order to control the pump and valve.
Input Signal Output Signal Engine Control (ECM) Engine Control Dial Engine Control Dial Control Pump 1 Control Pressure Sensor HP Mode Control Pump 2 Control Pressure Sensor Travel HP Mode Control E Mode Control Pump 1 Delivery Pressure Sensor Auto-Idle Control Pump 2 Delivery Pressure Sensor Pump 3 Delivery Pressure Sensor (Optional) Auto-Warming Up Control Idle Speed-Up Control Pressure Sensor (Travel) Heater Control Pressure Sensor (Front Attachment) * Attachment Operation Speed Increase Control Pressure Sensor (Swing) MC * Attachment Operation Speed Limit Control Pressure Sensor (Boom Raise) Pressure Sensor (Arm Roll-In) Pressure Sensor (Auxiliary) (Optional) Pump Control (Torque Control Solenoid Valve) Pressure Sensor (Arm Roll-Out) (Optional) Speed Sensing Control Oil Temperature Sensor Travel Torque-Up Control Auto-Idle Switch * Attachment Pump Torque Decrease Control * Pump 1 Flow Rate Limit Control * Pump 2 Flow Rate Limit Control * Pump 3 Torque Decrease Control Continued to T2-2-2 NOTE:
*This control is for only the machine with optional parts equipped. T2-2-1