SYSTEM / Control System Arm Regenerative Control Purpose: Accelerates the arm roll-in speed in order to prevent arm hesitation during arm roll-in operation. Operation: 1. MC activates solenoid valve unit (SC) so that solenoid valve unit (SC) delivers pilot pressure when the signals from pump 1, 2 delivery pressure sensors, swing pressure sensor, arm roll-in pressure sensor and boom raise pressure sensor meet the following conditions. 2. This pilot pressure shifts the arm regenerative valve and the return circuit from arm cylinder rod side to the hydraulic oil tank is closed. 3.
Then, return oil from the arm cylinder rod side is combined with pressure oil from the pump and is routed to the cylinder bottom side so that arm roll-in speed increases and prevents arm hesitation. (Refer to Control Valve/ COMPONENT OPERATION.) 4. At the same time, pilot pressure from solenoid valve unit (SC) shifts the arm flow rate control valve in arm 2 parallel circuit. 5. Therefore, as pressure oil through arm 2 parallel circuit is controlled and delivered to boom 1, so that boom raise speed is kept. Conditions: Pump 1 and 2 Delivery Pressure Sensors: Either pump 1 or 2 delivery pressure is low. (The arm does not need much power to operate.) (Reference:
16.5 MPa (168 kgf/cm 2 , 2400 psi) or less) Arm Roll-In Pressure Sensor: High output. (The arm control lever stroke is large.) (Reference: 0.5 MPa (5.1 kgf/cm 2 , 73 psi) or more) Swing or Boom Raise Pressure Sensor: Outputting signal. T2-2-48