SYSTEM / Control System Work Mode Control The work modes include digging and front attachment 1 to 5 and are selected by the work mode on monitor unit. Digging Mode: Normal control is performed. Front Attachment Mode: Functions only when the attachment in the optional kit is operated. In response to attachment control operation, increasing or decreasing of engine speed (refer to T2-2-24, 26.), increasing or decreasing pump flow rate (refer to T2-2-36, 38.) and valve selection (refer to T2-2-58 to 63) are controlled. The engine speed and pump flow rate control settings are made by using Dr. ZX. NOTE:
As the attachment mode, one to five attachment modes can be selected from breaker 1 to 5, secondary crusher 1 to 5, crusher 1 to 5 and vibrating hammer 1 to 5 by using Dr. ZX T2-2-66