COMPONENT OPERATION / Pump Device Control by Own or Opponent Pump Delivery Pressure Decreasing Flow Rate 1. When the pump is loaded by operating any of the control levers, either pump 1 delivery pressure Pd1 or pump 2 delivery pressure Pd2 increases. (During operation, pump control pressure Pi is kept increased.) Load piston 1 (5) is moved toward direction of the arrow by pilot pressure Pps. 2. Load piston 2 (6) pushes spool B (7), inner spring (9) and outer spring (10). Spool B (7) moves toward direction of the arrow. 3. Due to the movement of spool B (7), pilot pressure is routed to the large chamber of servo piston (11). 4.
Due to the difference in diameter between the large and small chambers, servo piston (11) moves toward direction of the arrow. The cylinder block is rotated in the minimum inclination direction and the pump delivery flow rate decreases. 5. The movement of cylinder block is transmitted to sleeve B (8) via link (13). Sleeve B (8) is moved in the same direction as spool B (7). 6. When sleeve B (8) is moved by the same stroke as spool B (7), the open part between sleeve B (8) and Spool B (7) is close and pilot pressure to servo piston (11) is blocked. Therefore, servo piston (11) is stopped and the flow rate decreasing operation is completed.
Flow Rate (Q) Pressure (P) 0 Dr Bleeding T1V1-03-01-005 Increase Decrease Cylinder Block Inclination 5 - Load Piston 1 9 - Inner Spring 6 - Load Piston 2 10 - Outer Spring 7 - Spool B 11 - Servo Piston 8 - Sleeve B 13 - Link Pd1 - Pump 1 Delivery Pressure Pi - Pump Control Pressure Pd2 - Pump 2 Delivery Pressure Pps -Torque Control Pressure Dr - Returning to Hydraulic Oil Tank Pg - Primary Pilot Pressure (From Pilot Pump) T3-1-14 5 Pi Pd1 Ai Bl Ci Pps Dr Pd2 Dr 9, 10 6 8 7 Pg 11 13 T1V Dr 9, 6 8 7 Pg Pi Ai Bl Ci Dr 9, 10 6