COMPONENT OPERTATION / Control Valve OVERLOAD RELIEF VALVE (with Make-Up Function) The overload relief valves are located in the boom, arm, bucket and positioning control valve circuits. The overload relief valve prevents each actuator circuit pressure from rising excessively when the actuators are moved by external loads. In addition, when the actuator circuit pressure is reduced, the overload relief valve draws the hydraulic oil from the hydraulic oil tank and prevents the occurrence of cavitation (make-up function). Make-Up Operation 1. When pressure in port HP (actuator circuit) decreases lower than port LP (hydraulic oil tank), the sleeve moves to the right. 2.
Hydraulic oil flows in port HP from port LP and cavitation is prevented. 3. When pressure in port HP increases more than the specified pressure, the sleeve is closed by the force of spring C . For Positioning Control Valve NOTE: The operations of overload relief valves in boom, arm, bucket and positioning control valve are same. Therefore, the operation for boom, arm and bucket is shown here. Relief Operation 1. Pressure in port HP (actuator circuit) acts on the pilot poppet through an orifice in the piston. 2.
When pressure in port HP increases more than set-force of spring B, the pilot poppet is unseated and pressure oil flows to port LP (hydraulic oil tank) through passage A and clearance around the sleeve. 3. At this time, a pressure difference arises between port HP and the spring chamber due to the orifice. 4. If this pressure difference increases more than set-force of spring A, the main poppet is unseated so that pressure oil in port HP flows to port LP. 5. Thereby, the actuator circuit pressure decreases. 6. When the actuator circuit pressure decreases to the specified level, the piston and main poppet are seated by the force of spring A.
Spring C Spring A Main Poppet Seat Sleeve Orifice A HP Valve Spring B Spring Chamber Pilot Poppet Passage A T198-03-03-006 LP T3-3-30