hitachi — DIGGING REGENERATIVE VALVE

COMPONENT OPERTATION / Control Valve DIGGING REGENERATIVE VALVE The digging regenerative valve is provided in the return circuit of boom lower and functions during combined operation of boom raise and arm roll-in. When the digging regenerative valve is shifted, pressure oil from the boom cylinder rod side (return side) through the digging regenerative valve is combined with pressure oil from pump 2 and flows to the arm 1 spool. Therefore, speed of arm roll-in increases. (Refer to Section "Control System"/ SYSTEM.) Operation 1. When solenoid valve unit (SF) is driven by the signal from main controller (MC), pressure oil from the pilot pump flows to port SF through solenoid valve unit (SF). 2.

Pressure oil from port SF acts to the end of spool through the inner passage. 3. The spool moves downward by compressing the spring. 4. Therefore, pressure oil from the boom cylinder rod side (return side) opens the check valve, is combined with pressure oil from pump 2 and flows to the arm 1 spool. 5. Consequently, as oil flow rate to the arm cylinder increases, speed of arm roll-in increases. Inner Passage Check Valve SF Spool Pilot Pressure from Solenoid Valve Unit (SF) Return Oil from Boom Cylinder Rod Side Spring Digging Regenerative Valve T1V1-03-03-069 T3-3-40 To Arm 1 Spool