COMPONENT OPERATION / Travel Device While Traveling: 1. When pressure oil from the control valve flows to port BV (8), pressure oil flows around the outer diameter of spool (9), unseats check valve BC (7) and flows further to motor port BM (6). 2. On the other hand, return oil from the travel motor is routed to motor port AM (4). However, its pas- sage is blocked by check valve AC (3) and spool (9). 3. When pressure in port BV (8) increases further, pressure oil is routed into chamber B (10) through orifice (f) in spool (9) and moves spool (9) to the right. 4. Consequently, return oil from the travel motor flows to port AV (1) through notch (h) on spool (9).
Then, pressure oil is allowed to flow so that the travel motor starts rotating. 5. When the travel lever is returned to neutral, spool (9) is returned to the original position by spring force and blocks the oil passage so that the travel motor rotation is stopped. While Descending: 1. While descending a slope, the travel motor is forcibly rotated by the machine weight so that the motor operates like a pump. 2. If the travel motor draws oil, oil pressure in port BV (8) and chamber B (10) decrease, spool (9) moves to the left so that return oil from the travel motor is restricted. 3. Therefore, pressure in motor port AM (4) in- creases and brakes the travel motor. 4.
Once pressure oil is restricted, pressure in motor port BV (8) increases again and moves spool (9) to the right. As this operation (hydraulic braking operation) is repeated, the machine is prevented from running away. Circuit Protection Operation: 1. When pressure in the circuit increases over the set-pressure of overload relief valve (5), overload relief valve (5) is opened and high-pressure oil re- lieves to the low pressure side so that the travel motor is protected from being overloaded. 2. In addition, overload relief valve (5) relieves the shock loads developed due to inertia force when stopping the travel motor. 3.
If the travel motor draws oil like a pump, check valve BC (7) is unseated (make-up operation) so that cavitation is prevented. T3-5-14