hitachi — MC: MAIN CONTROLLER

SYSTEM / Controller Auto-Idle Control All Control Levers: Neutral Position Auto-Idle Switch: ON On conditions above, MC sends the signal to ECM and set engine speed to auto-idle speed. When operating the engine control dial, shifting the power mode switch (E mode to P mode or P mode to E mode) or operating front attachment/travel, auto-idle control is released. Auto-Warming Up Control When hydraulic oil temperature is below 0 ° C (32 ° F) for 15 minutes after starting the engine, MC sends the signal to ECM in response to the signal from key switch and hydraulic oil temperature sensor, and increases engine speed to auto warm-up speed. Idle Speed-Up Control Engine Speed:

Between Slow Idle and Idle Speed-Up Speed When operating front attachment or travel on condition above, MC sends the signal to ECM and increases engine speed to idle speed-up speed. Heater Control Coolant Temperature: Less than 5 ° C (41 ° F) Pump Control Pressure of Pumps 1 and 2: 0.5 Mpa (5.1 kgf/cm 2 , 37 psi) or less Engine Control Dial: Fast Idle Position When the engine starts on conditions above, MC sends the signal to ECM and increases engine speed beyond fast idle speed. Attachment Operation Speed Increase Control (Optional) Set attachment operation speed to increase (+) in the service mode of Dr. ZX. Engine Control Dial: Fast Idle Position Power Mode Switch:

HP Mode Position When operating attachment on conditions above, MC sends the signal to ECM and increases engine speed to attachment operating speed set by Dr. ZX beyond fast idle. Attachment Operation Speed Limit Control (Optional) Set attachment operation speed to decrease (-) in the service mode of Dr. ZX. When operating attachment, MC sends the signal to ECM and decreases engine speed to the attachment operating speed set by Dr. ZX below fast idle. T2-1-6