MACHINE OPERATIONS AND CONTROLS OPERATION Set the work equipment to the maximum left offset posture shown in the diagram on the right, then pull in the arm and check that it stops automatically when it comes close to the operator's compartment. When it stops, move the arm out and cancel the automatic stop. Set the work equipment in the posture shown in the diagram on the right, operate the left offset and check that it stops automatically when it comes close to the operator's com- partment. When it stops, lower the boom and cancel the automatic stop. If any abnormality is found during the inspection, use the procedure in Item 3 to warm up the hydraulic oil.
Then, carry out the inspection again. If there is still an abnormality, move the machine to a safe place, stop the engine, and contact your Komatsu dis- tributor for inspection and repair. 3-50