OPERATION MACHINE OPERATIONS AND CONTROLS Operation When There Is Automatic Stop 0. After using the cancel switch to cancel the automatic stop, never try to raise the boom, pull in the arm, or operate the left offset. After automatic stop, it is impossible to raise the boom, pull in the arm, or operate the left offset. Move the work equipment to the front or to the right to move it away from the operator's compartment, then carry out normal operations. REMARK After automatic stop, even if the work equipment is moved 5 to 10 cm (2.0 to 4.0 in) to the front or right, it is impossible to raise the boom, pull in the arm, or oper- ate the left offset, but this does not indicate a failure.
After automatic stop, if the work equipment is moved forward approx. 50 cm (20 in) and the boom is raised or the arm is pulled in, the movement will be slow (if the engine is running at low idling, it may even be impossi- ble to raise the boom or pull the arm in), so move the work equipment more than 50 cm (20 in) before carry- ing out operations again. When the machine is not being used, lower the work equipment to the ground. If there is hydraulic drift and the bucket enters the emergency stop range, the work equipment will not move when the engine is started again. Do not use the left offset when transporting the machine.
If there is hydraulic drift and the bucket enters the emergency stop range, the work equipment will not move when the engine is started again. 3-75 WARNING